Bearing units Diamond flange unit/Square flange unit
- Sealing both front and back to extend bearing life effectively in water and dust atmospheres.
- Lighter and easier to handle than steel bearing units.
-
Application
These products are used for bearings such as driver and driven shafts. Since it is sealed on both the front and back, it can be used under water environment and dust conditions.
-
Usage image
■Diamond Flange Unit
■Square Flange Unit
Features
Sealing both front and back
Water infiltration will cause rust since regular bearing units are not sealed in the back. Tsubaki's Bearing units have seals on both front and back, which are effective in extending the life of bearings.
Regular bearing units
Tsubaki Bearing Units
Housing is rust-resistant
Even if the bearings are lubricated, rust can still occur in the housing section. This rust can be a problem in food factories.
Tsubaki bearing unit housings are made of reinforced engineering plastic to prevent rust and keep conditions clean.
Lightweight/Easy to handle
Significantly lighter and easier to handle compare to steel bearing units.
Lineup
Diamond Flange Unit
Type | Closed type | Open type |
---|---|---|
Model No. | TP-C54204NR-ECT-UCFL | TP-C59204NR-ECT-UCFL |
Shaft Bore Diameter mm | Φ20,Φ25 | |
shape |
Square Flange Unit
Type | Closed type | Open type | ||||||
---|---|---|---|---|---|---|---|---|
Model No. | TP-C50205VREC-UCFQ | TP-C50206VREC-UCFQ | TP-C50207VREC-UCFQ | TP-C50208VREC-UCFQ | TP-C55205VREC-UCFQ | TP-C55206VREC-UCFQ | TP-C55207VREC-UCFQ | TP-C55208VREC-UCFQ |
Shaft Bore Diameter mm | Φ25 | Φ30 | Φ35 | Φ40 | Φ25 | Φ30 | Φ35 | Φ40 |
shape |