Return rollers and spacers for stainless steel Top Chain
Use return rollers on the return way of the conveyor to support the top surface of the chain.
- Top chain components
Return Rollers, Spacer For Stainless Top Chains
1．Return Rollers For Stainless Top Chains Line-up
Return Rollers For Stainless Top Chains (TP-C**NT-RR)
Model No.: TP-C12822NT-RR
- Material: High-density polyethylene
- For use with stainless steel top chains.
- *Equivalent to MB
- MB73-5068-RR
Return Rollers For Stainless Top Chains (TP-C**NT-DR)
Model No.: TP-C12862NT-DR
- Material: High-density polyethylene
- For use with stainless steel top chains.
- *Equivalent to MB
- MB125-68873-DR
2. Spacer
Spacer (for 82.6mm plate width)
Model No.: TP-C12824NT-DT
- Material: Polyamide
- For plate widths other than 82.6mm, cut PVC pipe or similar material to the required width and assemble with the return roller shown above.
- *Equivalent to MB
- MB126-6252-DT
3. Usage examples for stainless steel Top Chain return rollers
- Parts used
- Both ends: Return roller (for stainless steel Top Chain )
- Middle area: Return roller (for stainless steel Top Chain )
- Layout
- TT1905 multi-line conveyor
- Reasons for use
- To prevent conveyed objects from being scratched by supporting them with a chain roller on the return way
-
Uses PVC pipe as a spacer
*Can be adjusted to match plate width.
Return roller installation examples
Disc Plates/Guide Flange
2 return rollers and spacers
Split-Hub Return Roller (with flange)
When the direction of travel between two strands of chain is backward, or their speeds are different
- Use PVC pipe or similar material instead of the spacer shown above to adjust the distance between return rollers when the plate width is greater than 83mm.
- Return rollers for stainless steel top chain will not rotate when combined with plastic chain, and may cause uneven wear of top plate surfaces.
-
See illustration below for wide width Top Chain.
Notice: Curved frame end sections should not be in the inner side of the guide width.
